Assembly Instructions
Oasis & Oasis+ Raised Garden Bed
5 simple steps. All you need is a Robertson or Phillips screwdriver.
Hardware Included
for OASIS & OASIS+ 16″H
CAUTION — Sharp edges — Please ensure safety lip is at the top — Gloves recommended
Slide First Panel into Post
Place a corner post on a flat surface. Slide the first panel into the post channel with the integrated safety lip facing up. Install hardware loosely — don't fully tighten yet.
From the outside in: bolt → garden bed → sealing washer → flange nut. The sealing washer goes on the interior side only, with the neoprene (black side) facing toward the garden bed.
A pair of pliers can be helpful for holding nuts in place while tightening.
Add Second Panel to Form an L
Slide the second panel into the other side of the corner post, forming an L shape. Install hardware loosely.
Attach Posts to Open Ends
Slide a corner post onto the open end of each panel. Install hardware loosely on both posts.
Add Third Panel to Form a U
Slide the third panel into a post at the end of the first panel, forming a U shape. Install hardware loosely.
Close with Final Panel
Slide the fourth corner post onto the open end of the third panel. Then slide the final panel into the remaining open post channels to complete the garden bed. Install hardware loosely.
Final step: Tighten all hardware
Once all four panels and posts are connected, go back and fully tighten every bolt evenly. This ensures a secure, uniform fit.
