Assembly Instructions
Harvest Raised Garden Bed
4 steps. All you need is a Robertson or Phillips screwdriver.
Select your bed height
Hardware Included
for HARVEST 8″H / 12″H
Please note: Harvest Mini 8"H,12"H, 22″H and 30″H do not require support rods.
CAUTION — Sharp edges — Please ensure safety lip is at the top — Gloves recommended
Lay Out All Four Pieces
Place all four sections on a flat surface with the integrated safety lip facing up.
Create Two U Shapes
Connect two pieces together to form a U shape. Install hardware loosely — don't fully tighten yet. Repeat with the other two pieces to make a second U shape.
A pair of pliers can be helpful for holding nuts in place while tightening.
Connect the Two U Shapes
Bring the two U shapes together to form the garden bed. Leave two bolt holes open in the middle of each long side for the support rods. Install hardware loosely on all other holes.
Install Support Rods
Insert the threaded support rods through the open holes in the middle of each long side. Secure each end with a sealing washer, wing nut, and cap nut.
Final step: Tighten all hardware
Once everything is connected, go back and fully tighten every bolt and nut evenly. This ensures a secure, uniform fit.
